Features:
- ARM 32-bit RISC CPU
- 10/100 base-T automatically check high speed communication terminal
- Support Modbus/TCP communication protocol, easy to integrate
- Support UDP event dealing function
- Can transmit 100M without any repeater
- Can remote configure through Ethernet
- Allow 8 PC visit at the same time
- 8 I/O slot can support128 point data monitor
- 1500VDC Ethernet communication isolation
- Build-in system auto-reposition watchdog
- Windows tool: I/O model configure and calibrate, network automatically
search data stream setup, present status monitoring and warning trigger.
- Provide ActiveX driver for user developing
Specification:
- Processor:
CPU: 32-bit RISC CPU
I/O model capacity: 4 slot
Memory: 4MB RAM 512KB Flash ROM
Operating system: real-time OS
Status display: power (3.3V, 5V), CPU, communication
(link, active, 10/100Mbps, TX, RX)
CPU power consumption: 5.0W
Reset switch : yes
- Isolation protection
Ethernet Communication; 1500VDC
Communication power 3000VDC
I/O model isolation:3000VDC
- Diagnosis:
Power up Self test : hardware and software
- Ethernet
Interface: 10/100Base T
Lead: UTP, 5 or higher wire
Bus connection: RJ45 model slot
Communication protocol: Modbus/TCP,TCP,UDP,IP,ARP
Data transmitting speed: Max 100Mbps
Max communicate distance: 100m without repeater
Response time: less than 5ms
- Mechanical features:
Coating: ABS plastics, with install accessories
Plug-in screw terminator: diameter of lead 0.05mm2 to 2.5mm2, 1-#12 or 2-#14 to #22AWG
- Serial network:
Interface: RS-485
Communication protocol: ModBus/RTU
Max vertices: 32
Baud rate: 115.2Kbps
- Power requirement
Unconditioned: +10-30VDC
Over voltage protection and Reverse power protection
- Software support
ActiveX Driver
Windows tool: network setting, I/O configuration and standard, data stream, warning setting
Modbus/TCP OPC Server
- Environment:
Operating temp –10℃~+70℃
Storage temp –25℃~+85℃
- Humidity: 5~95% non-condensing
Order information:
RemoDAQ-9420 ethernet (8 slots) distributed data acquisition control system.